JMS In Dash Mount Install for EX Switch

JMS In Dash Mount Install for EX Switch

JMS IN-Dash Mount

Items needed:

Roto Zip

Clear Silicone (if needed)

Using a Roto Zip, hold it at a slight angle and cut a hole slightly smaller than a 2 1/2" long x 1 1/2" wide rectangle at a desired location. Use a file to clean off and adjust fit. If desired, use clear silicone on back to secure in place. Place switcher into mount before securing with silicone.

Clear color pictures of installed product are on our website.


    • Related Articles

    • EX and Gauge Switch Operation

      EX and Gauge Switch Operation

    • EX and Gauge Switch reprogram Instructions

      EX and Gauge Switch reprogram Instructions

    • No-Start Issues

      CAUTION: DO NOT TOUCH, UNPLUG, INSTALL CHIP, REMOVE CHIP WITH KEYS IN THE IGNITION.  ALWAYS REMOVE KEYS AND PLACE IN POCKET OR DISCONNECT BOTH BATTERIES TO ENSURE YOU DO NOT DAMAGE PCM Truck will not start with chip in. Does PCM calibration code ...

    • F5 and F6 Chips

      We have two chip options, the F5 and F6. Here are the differences.   F5 holds 16 tunes total F6 holds 16 tunes total   F5 has multiple LED switch options or rotary switch can be selected F6 has multiple LED switch options or rotary switch can be ...

    • Chips Versus Programmers

      If you are looking for tuning for your 7.3, we have a couple main options  to consider. We have a product called the Infinity which is a Programmer and we have two chips called F5 and F6. Let’s look at the differences.  In general, programmers ...